Resultaten 1 tot 2 van de 2

Onderwerp: Hanger Family

  1. #1
    Junior Member
    July 12, 2017
    Huidige lokale tijd

    Not allowed! Not allowed!

    Hanger Family

    I am working on a job that was previously modeled with conduit hangers. I need the rod length to be 2" above the pan deck. Is there a way to modify the family to automatically look for the deck and attach to it? I am going through and individually moving every rod to the length I need.

  2. #2
    Forum Co-Founder Alfredo Medina's Avatar
    December 7, 2010
    Orlando, FL, USA
    Huidige lokale tijd

    Not allowed! Not allowed!
    To avoid having to adjust every single hanger manually, I can mention two solutions:

    1) Convert the duct or pipe to fabrication parts, then use the hangers from the Fabrication tool. Those are "smart hangers" that find the nearest supporting element above, and adjust the rod(s) to the proper length, and also, adapt the width of the hanger to the duct or pipe. If you want to learn more about this, see this:

    2) Buy an add-on. There are some that do amazing things about hangers. Check Youtube or Linkedin for videos about this. Two of them are: AgaCAD and MagiCAD.
    Laatst gewijzigd door Alfredo Medina; 16-12-18 om 22:32. Reden: add-ons

Gelijkaardige Onderwerpen

  1. Hanger Schedule
    Door swooll3 in forum MEP - General
    Reacties: 2
    Laatste Bericht: 17-10-17, 11:11
  2. Reacties: 2
    Laatste Bericht: 07-04-16, 05:24
  3. Hanger tag re-number
    Door Brocha in forum MEP - General
    Reacties: 10
    Laatste Bericht: 18-08-15, 20:18
  4. Hanger Columns
    Door kev4174 in forum Structure - General Questions
    Reacties: 10
    Laatste Bericht: 09-08-13, 08:26
  5. thewrz's super awesome hanger family
    Door thewrz in forum MEP - Family Creation
    Reacties: 0
    Laatste Bericht: 10-02-12, 16:58

Forum Rechten

  • Je mag geen nieuwe onderwerpen plaatsen
  • Je mag geen reacties plaatsen
  • Je mag geen bijlagen toevoegen
  • Je mag jouw berichten niet wijzigen