Announcement

Collapse
No announcement yet.

Visibility

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Visibility

    I have an electrical plan that also shows plumbing, is there a way to also show the mechanical ducts?
    I have to show locations for the duct detctors. I know in ACAD you would have to thaw a layer but in Revit I don't know.
    I'm sure its possible cause I have the piping shown already. if anyone has knowledge in this, your input would be appreciated.
    chris.

    #2
    you might have probably answered your question by now..
    just look for Revit's "Layer" equivalent. Check the Visibility of all Duct elements in Visibility/Graphic Overrides (VV). :thumbsup:
    “You can't think AutoCAD and run Revit.”
    -Anonymous

    Comment


      #3
      Salamat Pare.

      Comment


        #4
        Visability Hierarchy

        Check this link out too. It may help in future.
        Revit Visibility Hierarchy - The Revit Clinic

        Ciao for now.
        Say something interesting....

        Comment

        Related Topics

        Collapse

        • Riser Duct Visibility Issue
          In my project I am facing an issue with visibility of fresh air riser duct. This riser duct running from GF to Third FF.This duct is visible at all floor...
          July 21, 2011, 11:19 AM
        • How to constrain visibility paramater
          Hello Everyone

          While working today a got a dout that if visibility paramater can be constrained, like if there are 2 visibility paramater,...
          October 29, 2013, 05:49 AM
        • Duct set down/setup - visibility Issue
          From One challenge to another and thanks for this forum offering solution.

          Currently the floor plan has filled duct system color through...
          December 10, 2020, 10:17 AM
        • Invisible duct risers
          Hi everyone,
          I'm having an issue in Revit 2012 where all ducts drawn that run perpendicular to the plane I am viewing are invisible, i.e. duct...
          August 18, 2011, 06:37 PM
        • System connections
          Hi,

          Working on a ductwork model where we have new and existing. I have done some reading that prior to 2013 the systems would lose connection...
          May 7, 2016, 08:38 PM
        Working...
        X