Another Sweep Question...

sachez143

Member

Join Date: November 7, 2011

Posts: 64
#1

Another Sweep Question...

January 18, 2012, 11:35 AM

... is there a way to get a sweeps elevation to go from high to low to high again,
I have a roof that has three bays and the middle bay is high, can i sweep an edge angle and have it follow the varying slope?
If so, how?

Also I want it to turn the corner and then run flat along the sides.

Last edited by sachez143; January 18, 2012, 01:28 PM.

Yep - It's me Again, and Again, and Again.......
Tags: None
dzatto

Moderator
"OMG I killed Revit"

Join Date: December 9, 2010

Posts: 5374

Location: Dallas, TX
#2

January 18, 2012, 02:08 PM

Not that I know of. This is where you would use the fascia tool with a profile. You'll probably need to put in model lines first, unless you can attach the fascia to the roof. This sounds like it's going on a parapet, though. See the attached cornice on this building. Done with the fascia tool.
Attached Files

Dan
Comment

Previous template Next

Best way to model capping around 3 sides of a skillion roof

Think im in brainfade. Im looking for the simplest way to model the capping around the 3 sides of an 8degree pitch skillion roof. Yes, seperate pieces...
- Channel: Architecture and General Revit Questions
November 17, 2017, 09:57 PM
Decorative Cornice

Hi.

What would be the best way to create this decorative cornice for the top of a building? I'm thinking wall sweep, but it has different...
- Channel: Architecture and General Revit Questions
January 8, 2014, 12:39 PM
sweep did not work with me to draw cornice along roof

i did sweep by drawing profile on side and sketch path but it faild with me i do not know maybe because there is two workplane i picked
the method...
- Channel: Architecture and General Revit Questions
August 25, 2011, 02:55 PM
Parapet Wall Coping

Can anybody advise me on how to create a simple parapet wall coping?
- Channel: Architecture and General Revit Questions
February 7, 2012, 11:09 AM
help with the sweep tool

Hi guys,

I'm trying to create a flashing that goes around a pitch roof, that's flushed against the roof, not angle to one direction....
- Channel: Architecture - Family Creation
November 16, 2019, 03:38 AM

Welcome to the Revit Forum