Question regarding modifying sub elements

andreakset

Member

Join Date: November 17, 2011

Posts: 28
#1

Question regarding modifying sub elements

November 17, 2011, 10:01 PM

Hi,

Is it a way to modify the sub element of a floor to create a slope on top and keeping the bottom flat?

Best regards,
-Andre
Attached Files

modify subelement.PNG (16.8 KB, 30 views)
Tags: None
Munkholm

Administrator

Join Date: December 7, 2010

Posts: 4370

Location: Kingdom of Denmark
#2

November 17, 2011, 10:10 PM

Almost the same check box as the previous question :beer:
Attached Files

18-11-2011 00-09-15.jpg (71.4 KB, 46 views)

Klaus Munkholm
"Do. Or do not. There is no try."
Comment
andreakset

Member

Join Date: November 17, 2011

Posts: 28
#3

November 17, 2011, 10:19 PM

Thanks again! I need to start checking there first from now :beer:
Comment

Previous template Next

Modify Sub Elements - Grips not active

I am trying to manipulate a floor surface to provide some multi-directional slope. I am utilizing the modify sub elements tool. when selecting this tool...
- Channel: Architecture and General Revit Questions
April 19, 2017, 03:44 PM
Floor with different slopes on top and bottom

Once you slope a floor, there is no way to modify sub elements, correct?

I have a floor that is flat and sloped longitudinally on the bottom....
- Channel: Architecture and General Revit Questions
May 25, 2017, 01:01 AM
Floor Slope

I have a complex slab that I need to slope (4 ways). The floor high point is 4 inch higher than at the trench level... I'm not sure how to achieve this......
- Channel: Structure - General Questions
September 24, 2014, 08:14 PM
Slope one element of a floor assembly

Hey, in section to detail a floor with several layers, one of the layers is sloped for water drainage, the floor base and top finish are flat (no slope)...
- Channel: Architecture and General Revit Questions
October 9, 2014, 08:46 AM
make element editable

seems i have to do it one by one even i selected all instances, did i miss something simple?
- Channel: Architecture and General Revit Questions
July 28, 2011, 10:49 PM

Welcome to the Revit Forum