Wall sweep don't cut the door frame

MARIA1993

Senior Member

Join Date: October 16, 2016

Posts: 451
#1

Wall sweep don't cut the door frame

July 23, 2018, 10:00 AM

Hello all,

As you can see in the images the wall sweep overlap the frame of the door (image 1). If I go to the door family and extend the opening cut until the frame..the result that I have in the floor plan isn't correct (image 2).

Any idea?

Thank you in advance!

Attached Files
Tags: None
sdbrownaia

Forum Addict

Join Date: December 20, 2010

Posts: 1219
#2

July 23, 2018, 05:58 PM

You have to build a frame to your door family as you would have in real life, then all is well or at least close to it.

Scott D. Brown, AIA | Senior Project Manager | Beck Group
Comment

Previous template Next

Baseboard Automatic Cut by Door Frame?

Wall sweep basboard goes to door opening, rather than stopping at door frame. It is usually fine since it is relatively easy to move the blue grip dot...
- Channel: Architecture and General Revit Questions
June 2, 2013, 11:57 PM
Plasterboard returns into door frames

I want to have the outer layer of a party wall (the plasterboard) return into the door frame on one or both sides.
If I use Wall Closure reference...
- Channel: Architecture and General Revit Questions
April 26, 2013, 09:53 AM
pocket door will not cut base sweep

I have a standard family "double-pocket" door that will not cut through my wall base sweep. I have made the sweep cuttable and cuts walls,...
- Channel: Architecture and General Revit Questions
April 3, 2011, 07:05 PM
Skirtings & Inserts

Example: (typically) a door frame architrave returns at the corner edge of a door opening (simply speaking). In Revit, placing a skirting (let's for the...
- Channel: Architecture and General Revit Questions
November 24, 2015, 09:42 AM
Door trim not behaving...

I am using an OOTB door to cut a stacked wall. The door cuts it fine, but the trim only cuts the upper portion of the stacked wall and not the lower....
- Channel: Architecture and General Revit Questions
October 15, 2013, 08:37 PM

Welcome to the Revit Forum