Snap mode

Ecotech Kid

Senior Member

Join Date: February 16, 2016

Posts: 144
#1

Snap mode

July 17, 2017, 02:52 PM

Hello I have accidentally created a roof by extrusion floating in space and I want to move it so that it accurately sits on a wall. Only problems is that when I grab it, snap highlights are nowhere to be seen.
Are snap grips only available in sketch mode or does roof have to be hosted on a wall or something?
Tags: None
biff

Senior Member

Join Date: June 13, 2011

Posts: 924

Location: Australia
#2

July 17, 2017, 09:13 PM

Elevation view should do it, or via a section.

Motorbike riding is one long bezier curve
Comment

Previous template Next

Revit gable roof problems

Hi,
Where am I going wrong with the below gable roof? I am trying to extend the wall up to the roof but am being left with this gap.

...
- Channel: Architecture and General Revit Questions
September 14, 2020, 08:48 PM
Recessed Roof Extending Into Walls

Hi Everyone, long time viewer but first time poster here! I've found this forum so useful so thought I'd ask about this issue I've run into and can't...
- Channel: Architecture and General Revit Questions
June 16, 2017, 11:24 AM
Roof - wall connection

Hello,
I'm relatively new to Revit and this forum and I hope I'm doing this right.
My problem ist, that when I make a section, the outer wall...
- Channel: Architecture and General Revit Questions
September 10, 2020, 08:18 AM
Roof/wall attachment question

I've got a condition where I'm trying to attach the base of a wall to a roof with an overhang. It attaches as I would expect it (including at the overhang),...
- Channel: Architecture and General Revit Questions
October 1, 2015, 06:38 PM
Editing roofs created by footprint

I am trying to edit a roof which has two ridge lines. When I try to move one to the same place as the other the whole roof moves. This probably because...
- Channel: Architecture and General Revit Questions
June 19, 2017, 05:16 PM

Welcome to the Revit Forum