Modeling either a roof form with a void or gutter that resides inboard?

DesignApparatus

Senior Member

Join Date: July 20, 2011

Posts: 191

Location: San Diego, CA
#1

Modeling either a roof form with a void or gutter that resides inboard?

April 25, 2017, 10:28 PM

I am trying to model a roof form with a gutter that resides inboard of the roof fascia, but still allows for the roof form to continue under the gutter to the inside edge of the fascia...any ideas out there? I tried reversing the gutter profile to the interior side of the hosting line, and it hosts there but disappears inside the roof form...it does not create a void. Not sure how I would construct a family for this.
Challenge for the day! You help me figure this one out and I will pick you up at the SD airport and buy you a beer!
Tags: None
Twiceroadsfool

Administrator

Join Date: December 7, 2010

Posts: 12243

Location: Dallas, TX
#2

April 25, 2017, 10:36 PM

Vertical Opening in the Roof, separate family (Roof Fascia) for the Gutter....

Aaron "selfish AND petulant" Maller |P A R A L L A X T E A M | Practice Technology Implementation
@Web | @Twitter | @LinkedIn | @Email
Comment

Previous template Next

another roof question

Hello,

I've been struggling with the following problem every now and then. The following case illustrates it well.
I have a pitched...
- Channel: Architecture and General Revit Questions
March 13, 2015, 01:54 PM
Notch A Roof By Extrusion

Okay, let me try to explain this. I have a gambrel roof by extrusion. Where my cupola's are, the window is below the ridge of the roof. So, I need...
- Channel: Architecture and General Revit Questions
August 1, 2012, 01:24 AM
Need help to create curve roof! Urgent!

Hi, i need help urgently with this roof profile. I need to create a roof that sweeps upwards, and is in a curve roof profile. Is there a way i can do...
- Channel: Architecture and General Revit Questions
December 30, 2011, 11:37 AM
water overflowing gutter at roof intersections

I have a ranch home. Approximately two thirds from one side, I have an entrance way porch with a roof. Thus the porch roof intersects the main roof. there...
- Channel: Out There
September 21, 2018, 03:31 PM
L-Shaped Shed roof - Revit

How to create an L-shaped shed roof in revit? I know its roof by extrusion for a simple shed roof but I don't know how to do it if it's L-shape. Thank...
- Channel: Architecture and General Revit Questions
May 18, 2016, 03:50 AM

Welcome to the Revit Forum