Hi everyone,
I am relatively inexperienced using Revit. I am making a model of a site that requires sloping Armco barriers.
From my research I see the best way to do this is by adaptive component's. I made the model and it works fine in the family builder, but when I load it in to my project and attach the model to the nodes on the mass the Armco barrier becomes distorted. The columns rotate 90 degrees and the barrier becomes flat.
I have attached images and the model, if anyone can tell me what I am doing wrong before I pull out the last bit of my hair, that would be appreciated
I am relatively inexperienced using Revit. I am making a model of a site that requires sloping Armco barriers.
From my research I see the best way to do this is by adaptive component's. I made the model and it works fine in the family builder, but when I load it in to my project and attach the model to the nodes on the mass the Armco barrier becomes distorted. The columns rotate 90 degrees and the barrier becomes flat.
I have attached images and the model, if anyone can tell me what I am doing wrong before I pull out the last bit of my hair, that would be appreciated

Comment