Place a non-hosted family onto ceiling.

andyrh1982

Member

Join Date: June 10, 2015

Posts: 91

Location:
#1

Place a non-hosted family onto ceiling.

December 8, 2016, 07:50 AM

Hello All,

How do you place a non-hosted family onto a ceiling?

The family in question is a heat sensor with sounder from a manufacturer. I was hoping to update all the generic sounder models that are hosted to a ceiling with this new family but an error message popped up and wouldnt host.

I have switched on the work plane base option and turned off always vertical but it will only host vertically.

Any suggestions?

Cheers
Tags: None
mrgrotey

Junior Member

Join Date: July 11, 2014

Posts: 47

Location:
#2

December 9, 2016, 02:54 PM

Originally posted by andyrh1982 View Post

Hello All,

How do you place a non-hosted family onto a ceiling?

The family in question is a heat sensor with sounder from a manufacturer. I was hoping to update all the generic sounder models that are hosted to a ceiling with this new family but an error message popped up and wouldnt host.

I have switched on the work plane base option and turned off always vertical but it will only host vertically.

Any suggestions?

Cheers

Have you tried inserting it in the 3D view rather than the elevations/floor plans? I find work plane based models insert more reliably in the 3D view
Comment

Previous template Next

Hosting Problem

I have got a Nurse Call Pull Switch which can only be hosted into a ceiling. When I try to host into the Ceiling on my Linked in Revit Model (Overlay...
- Channel: MEP - General
August 27, 2014, 09:25 AM
add lights to the ceiling

Hi,

what's the better way to place lights to the ceiling?

do you place them on face or on work plane?

do you work...
- Channel: Architecture and General Revit Questions
August 1, 2014, 04:24 AM
Placing Ceiling Bracket Vertically

I want to place the ceiling bracket vertically, but for some reason when i place it in the model in appears horizontally. i have got this family from...
- Channel: Out There
November 23, 2018, 04:39 AM
Hosting a Pendant light to a vaulted ceiling

I am trying to host a pendant light to a vaulted ceiling, and it will host just fine but will be on the same angle as the ceiling, how do I get it to...
- Channel: MEP - General
May 13, 2014, 05:47 PM
Air Terminals default to upside down when hosted to ceiling

Both generic air terminals in my firm's project template and families I have downloaded from Titus enter the model upside down with the plenum/inlet below...
- Channel: MEP - General
October 13, 2017, 08:35 PM

Welcome to the Revit Forum