How to attach curved beam to a column?

Minsc

Junior Member

Join Date: June 29, 2015

Posts: 5
#1

How to attach curved beam to a column?

December 4, 2016, 02:40 PM

Greetings.

Is there a way to assign a curved beam to a column. When I attach straight beam to a column I get those two parameters 'Start Attachment type' and 'End Attachment type' that I can set to 'Distance' so my beam moves automatically with the change of the column height. In case of a curved beam those parameters are not available.

Thanks.

Last edited by Minsc; December 4, 2016, 05:01 PM.
Tags: None
dannyspastics

New Member

Join Date: December 23, 2016

Posts: 2

Location: New York, NY, USA
#2

December 26, 2016, 05:37 AM

I am envisioning if as the beam was not cut or notched, only that flange (bearing plate) on top of the column was large enough to be bent up and over the bottom flange of beam...
Comment

Previous template Next

Beam to Column Connection (RHS Sections)

Hello Everyone

I have a beam to column connection which I want to bring the beam to sit over the column. The problem is, the beam won't extend...
- Channel: Structure - General Questions
October 10, 2013, 08:29 AM
Beam & Column Joins

I'm trying to adjust some beam & column connections in our arch model based on the drawings from the structural engineer and am lost. The beam bears...
- Channel: Structure - General Questions
October 24, 2013, 03:26 PM
What is the correct way in drawing a beam?

i have 3 columns for example & i want to install a beam between these 3 columns as attachment, what is the correct way to do that :-
1 - draw...
- Channel: Structure - General Questions
June 16, 2014, 07:16 AM
The column and target are joined, remove that join before attaching them.

I'm trying to attach a column to a beam near the end of the beam, but I get this error message. I've changed the top of the column to be well below the...
- Channel: Structure - General Questions
March 22, 2018, 11:16 PM
Stop Beam to Column Connection

I have a beam that is automatically connecting itself to a sloped column in the wrong location. Is there any way to "disconnect." I'd try...
- Channel: Architecture and General Revit Questions
November 15, 2011, 07:50 PM

Welcome to the Revit Forum