Announcement

Collapse
No announcement yet.

Stringer cut

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Stringer cut

    Hello

    Is it possible to remove sections of stringers from a stair? I want to remove the two stringers from the landing as shown in the image.
    Attached Files
    Tags: cut, stringer
    #2
    Sorry, but that´s impossible as far as I know... Can´t even do an in-place void since stairs is not an available category for families...

    BTW, you may wanna have a look at the center stringer at the second run... something is not right there
    Klaus Munkholm
    "Do. Or do not. There is no try."

    Comment

      #3
      No its not possible to remove sections but it is possible to add sections.
      In your example i would make the landing as a floor the create 3 separate stairs.
      Select your lower run and enter edit mode. Add extra boundary lines (green) for stringer additions. Select each of these extra lines and change Slope to Flat.
      With you top level runs enter edit mode and extend required boundary lines by pulling nodes towards landing this will extend the stringer into the new landing stringer.
      Hard to explain have a look and play with attached file.
      Attached Files
      Mark Balsom

      If it ain't broke, fix it till it is.
      • 👍 1

      Comment

        #4
        Thank's for the feedback chaps. Mark, I'll make the landing into a floor and try the boundary line option as suggested.

        Klaus, the middle stringer is in actual correct in revit, seems a problem with snagit.

        Comment

        Previous template Next

        Related Topics

        Collapse

        Monumetric Footer In-screen

        Collapse
        Working...
        X
        😀
        🥰
        🤢
        😎
        😡
        👍
        👎