Plumbing riser not cutting in plan

stl4310

Senior Member

Join Date: January 27, 2011

Posts: 346

Location: KC,MO
#1

Plumbing riser not cutting in plan

April 26, 2011, 04:45 PM

I have modeled-in-place a plumbing riser as a sweep (modeled as plumbing fixture). The pipe jogs in plan, on the third floor, yet the jog is showing up on every floor.

It appears as though Revit is not understanding that it needs to cut through the modeled component as it would a typical wall. Any suggestions as to how to get this thing to cut properly?
Tags: None
dzatto

Moderator
"OMG I killed Revit"

Join Date: December 9, 2010

Posts: 5331

Location: Dallas, TX
#2

April 26, 2011, 04:49 PM

Check the visibilty graphics of plumbing fixtures. I think that's one of the ones that do not cut. Like specialty equipment. Change the type to somethign that can be cut.

If you go to visibilty graphics by category, you can see the things that won't cut will be shaded in the cut column.

Dan
Comment

Previous template Next

Counterop Dissapears in Plan when Cut with Plumbing Fixture

Ladies & Gentlemen,

I've got a plumbing fixture family (sink) with a void in it. The family cuts with voids when loaded. I place it in...
- Channel: Architecture and General Revit Questions
August 16, 2018, 05:13 PM
Cut Plane Not Cutting Family Component

Hey Guys,

I have a down pipe that I'am wanting cut in my floor plan. I have changed the category from "Plumbing Fixture" to "Column"...
- Channel: Architecture and General Revit Questions
September 15, 2016, 11:22 PM
How to get two families to cut through one another

I have a situation where I have a sink family and a counter family, I want the sink to cut through the counter when I place them together. I understand...
- Channel: Architecture and General Revit Questions
January 6, 2020, 08:59 PM
Can't Cut It!!!

This is what I did:

1) Went into Mass Family (to start a new mass)

2) created a sphere

3) created a rectangular...
- Channel: Architecture and General Revit Questions
November 21, 2011, 06:41 PM
In-Place Family Not Cutting

I modeled a curtain track around the edge of a balcony in my model as an in place family. Everything looks fine in the RCP but when I cut it in section...
- Channel: Architecture - Family Creation
April 14, 2011, 09:52 PM

Welcome to the Revit Forum