Results 1 to 3 of 3

Thread: Duct fittings (reduction offset)

  1. #1
    Junior Member
    Join Date
    January 25, 2014
    Posts
    9
    Current Local Time
    04:06 PM

    Duct fittings (reduction offset)

    Hello,

    Maybe any of you have REDUCTION offset (flange) duct fitting? I can not make duct routing like this below;/
    Duct fittings (reduction offset)-1.jpg

    best regards

  2. #2
    Junior Member
    Join Date
    January 22, 2013
    Posts
    18
    Current Local Time
    03:06 PM
    This is a rectangular offset taper - flanged duct fitting
    you load this family and then you can use it
    Attached Thumbnails Attached Thumbnails Duct fittings (reduction offset)-duct-fitting.jpg  
    Last edited by hoss; January 7th, 2015 at 12:09 PM.

  3. #3
    Junior Member
    Join Date
    January 25, 2014
    Posts
    9
    Current Local Time
    04:06 PM
    could you add this file to attachment?

Similar Threads

  1. Replies: 0
    Last Post: January 15th, 2014, 05:45 PM
  2. Replies: 0
    Last Post: January 15th, 2014, 11:15 AM
  3. Pipe and duct fittings not part of systems
    By JamesLawrence in forum MEP - General
    Replies: 3
    Last Post: August 27th, 2013, 02:54 PM
  4. Revit Pipe / Duct Fittings to NWC Shifted Randomly
    By jbr12 in forum MEP - General
    Replies: 4
    Last Post: February 1st, 2013, 01:17 PM
  5. Duct Fittings Appear Ligther in Plan View
    By bgodava in forum MEP - General
    Replies: 3
    Last Post: June 12th, 2012, 04:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •