Wall sweep on an angled wall (modified wall profile)

[katewood1989]

I am trying to create a wall sweep on an angled wall that I created by editing the wall profile. Parts of the wall are unaltered, so the wall sweep profile I created works fine on those horizontal surfaces that were not modified/cut. (see attached image)

My previous understanding is that, I could go to component > model in-place, but there is no category including profiles or wall sweeps.

What are my options?

Thank you

[cliff collins]

You can model-in-place, Architecture tab>Component>Generic Model>sketch the Path and specify the Sweep Profile ( same Profile as your normal hor. wall sweep. )