Announcement

Collapse
No announcement yet.

Roof Edit-1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
    theshell07
    Member

  • theshell07
    replied
    Hi Munkholm & mark b

    Thanks for your valuable solutions. I have got what i want.

    Thanks

    Leave a comment:

  • mark b
    Moderator

  • mark b
    replied
    Just use the two walls that are equal off set from ridge in your diagram and just adjust the overhangs on either side.

    edit
    same resault as Munk but different approach
    Attached Files
    mark b
    Moderator
    Last edited by mark b; May 5, 2011, 02:24 PM.

    Leave a comment:

  • Munkholm
    Administrator

  • Munkholm
    replied
    Sure. When editing the sketch, pick the lines with the lower eaves, and give them a negative "Offset from Roof Base" (In the properties dialog)
    Attached Files

    Leave a comment:

  • theshell07
    Member

  • theshell07
    started a topic Roof Edit-1

    Roof Edit-1

    Hi


    Is it possible to do a roof as shown in the attachment using roof by foot print. Here the ridge is off centered and the layout is in the form of "L" shaped. So doing it using roof by extrusion is not so friendly at the intersection. Is there a way to do it by using roof by foot print.


    Thanks
    Attached Files

Related Topics

Collapse

Working...
X