Announcement

Collapse
No announcement yet.

Shaft opening

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Shaft opening

    I have created a shaft opening around a staircase to cut all my floors. It is very easy and quick, but now i have a problem with my landings. The landings in one side of the staircase is created as a floor and then the shaftopening also remove this...

    Do i really have 2 cut all my floors around the staircase?

    #2
    You could try to model the landings as in-place (stair category)
    Klaus Munkholm
    "Do. Or do not. There is no try."

    Comment


      #3
      The stair category is gone in my project ;-). But i tried the generic category, and it worked fine.

      Comment


        #4
        I tend to not even use shaft openings unless I have a common opening passing thru all floors, Like a Mech chase, or Elevator. I normaly just edit the floor to get the opening I need.

        Hope this helps.
        -Alex Cunningham

        Comment


          #5
          Originally posted by madsagger View Post
          The stair category is gone in my project....
          Wishful thinking on my part... :hide:
          Klaus Munkholm
          "Do. Or do not. There is no try."

          Comment

          Related Topics

          Collapse

          Working...
          X